Whats your Rwhp or hope to get

[whaisaturbo1000/rx7]

just got back from the dyno, 25 torque and 35hp at 30psi with a 150hp jet on the nitrous

[orange88]

just got back from the dyno, 25 torque and 35hp at 30psi with a 150hp jet on the nitrous

sweet so it blew up again.................

[BlownBOSS347]

my car hooks with 302rwhp i know people that cant hook with 200rwhp

Thats because you didn't make enough power to spin the tires.

[whaisaturbo1000/rx7]

sweet so it blew up again.................

no i was tring to be funny

[BlownBOSS347]

that was last year......

How is the project coming?

[BlownBOSS347]

its coming as money permits. almost there i should say, you get your done yet?..............we still need some guitar hero:cool:

Cool. Mine is making progress. Slowly but surely. The engine is at the builder, fuel system is partially in, trans is sitting in the back seat, hood is painted...

[BlownBOSS347]

a painted hood! holy shit saggin!

Yep finally got around to it. Mike (orange88) did the prep and spray work and it turned out awesome. From what I can tell it matches almost spot on. He did it without having the car there and only the wing to reference the paint.

Yep, I am goin up in the world, I now have a two-tone car again. Less RICE WWWWWWWWOOOOOOOO!!!

[BlownBOSS347]

when you hoping to have that thing done?

I am hoping to fire it sometime in late march, early april.

[BlownBOSS347]

i will have mine goin and probably blown up by then:rotfl:

Hopefully that isn't the case, I need some one to race right away.

[Guest]

300hp tq right now----hopefully ill get the whipple mocked up this year...prob not installed but started at least---so my horsepowers will prob stay the same

[BlownBOSS347]

got my new injectors today.......where can i get them flowed?

Either TPIS in Chaska or The Carb Shop in Maplewood does that.

[BlownBOSS347]

I am hoping to actually throw some heads on my car and possibly crest the 400 mark. Now i got all the time in the world to make that happen, but I dont know about money.

Name the time saggin, the heads will be installed. DOOOOOO IT.

[BlownBOSS347]

how much does it cost?

TPIS is by far the cheapest. I think it was like $50 or so to just flow them. I had mine cleaned and flowed by the carb shop in Maplewood. It was $200 I believe.

[1FASTV6]

well it made 854 and i had to get out of it early, so im hoping to make a touch over 1000 and ill be happy with that

I would personally do backflips for 854!! Of course im tryin to milk that out of 250 cubic inches with a 109 block, I have to be realistic......Lol