Rx7

[Toomanycars]

haha no sleeper here ... o well the lt1 in the other one fits under the hood so maybe they wont hear the turbo when i drive up :)

[MR.hp]

Good looking job on the cowl hood

[Toomanycars]

Started Puting the motor together Finally

[Toomanycars]

Got some work done on the hood ... Getting close

[Toomanycars]

http://www.youtube.com/watch?v=uJGPfJ1AuoE

[Toomanycars]

some primer sealer after a days worth of sanding

[RX-V8]

RX7 's are gay

[Toomanycars]

super gay ... thats why I own two

[Toomanycars]

[MR.hp]

Hey you got some vortec's, Yea. You will like the power from them.

[Z28SSMAN]

Vortecs? How can you tell? Because the valve covers bolt on from the center instead of the perimeter? Obviously I don't follow SBC stuff.

[Toomanycars]

this motor is a quick piece together ... Its a 91 350 4bolt main block .bored 30 over with trw forged pistons and some pink lt1 rods .. vortec heads that have been machined for more lift a stock lt4 cam full roller setup .. GM performance roller lifters and summit roller rockers. the intake is a no name intake i found cheep at a swap meet and i have a edelbrock 650 carb.. im backing it with a 700R4 .. this will stay in the car till I have my 400SBC done..

[Toomanycars]

ohh and i would like to try a victor jr intake on here as soon as i find a vortec styed one in my price range.

[MR.hp]

ohh and i would like to try a victor jr intake on here as soon as i find a vortec styed one in my price range.

Stay away from that unless you are racing as it hurts tq. in the lower rpm band by a bunch. The air gap or the regular RPM performer is a much better intake if you only spin the engine up to 6500. The Victor would be better if you are going to spray.

[Toomanycars]

Got the 7 back on the lift .. gona start on the tranny crossmember and some of the other stuff that needs to be finished up ..